2be23c475a
Dave Hylands reports: | We've observed a problem with dma_alloc_writecombine when the system | is under heavy load (heavy bus traffic). We've managed to reduce the | problem to the following snippet, which is run from a kthread in a | continuous loop: | | void *virtAddr; | dma_addr_t physAddr; | unsigned int numBytes = 256; | | for (;;) { | virtAddr = dma_alloc_writecombine(NULL, | numBytes, &physAddr, GFP_KERNEL); | if (virtAddr == NULL) { | printk(KERN_ERR "Running out of memory\n"); | break; | } | | /* access DMA memory allocated */ | tmp = virtAddr; | *tmp = 0x77; | | /* free DMA memory */ | dma_free_writecombine(NULL, | numBytes, virtAddr, physAddr); | | ...sleep here... | } | | By itself, the code will run forever with no issues. However, as we | increase our bus traffic (typically using DMA) then the *tmp = 0x77 | line will eventually cause a page fault. If we add a small delay (a | few microseconds) before the *tmp = 0x77, then we don't see a page | fault, even under heavy load. A dsb() is required after modifying the PTE entries to ensure that they will always be visible. Add this dsb(). Reported-by: Dave Hylands <dhylands@gmail.com> Tested-by: Dave Hylands <dhylands@gmail.com> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk> |
||
---|---|---|
.. | ||
alpha | ||
arm | ||
avr32 | ||
blackfin | ||
cris | ||
frv | ||
h8300 | ||
ia64 | ||
m32r | ||
m68k | ||
m68knommu | ||
microblaze | ||
mips | ||
mn10300 | ||
parisc | ||
powerpc | ||
s390 | ||
score | ||
sh | ||
sparc | ||
tile | ||
um | ||
x86 | ||
xtensa | ||
.gitignore | ||
Kconfig |